I2C - HT16K33 Animator (8x8)

How To Add This Control To Your Project

Step #1) Load the most recent release of EZ-Builder
Step #2) Press the Project tab from the top menu bar of EZ-Builder
Step #3) Press Add Control from the button ribbon bar of EZ-Builder
Step #4) Choose the I2C category tab
Step #5) Press the HT16K33 Animator (8x8) icon to add the control to your project


This control is for the Adafruit 8x8 LED Matrix Array, which uses the HT16K33 i2c chip. Once connected to the EZ-B v4 over i2c, this control lets you create animations using the 8x8 LED Array. The Adafruit LED module can be purchased here: http://www.adafruit.com/product/870

*Note: The INIT button must be pressed once the module is connected to i2c of the EZ-B. You may also use the EZ-Script's ControlCommand() to initialize the module programmatically.
Note: EZ-Robot is not a manufacturer of this third party hardware device. . Nor is ezrobot responsible for the operation of this third party device. For operational questions, it's best to consult the instruction manual for operational instructions.

Related Articles: N/A