Control Two Blinkm Leds - The Old Method Is Not Working

Assistance Requested

Help Asimo with their question and receive $10 of EZ-Credit to get more robots and parts from our store. The following information was provided about their previous efforts searching tutorials for a resolution.

Products: (click to view product details)

EZ-Builder Controls: (click to view manual page)

Asimo claims to have checked these sources:
 
#1

Dear EZ-Robot Profs,

I have a problem to give the BlinkM a new device adress.
I want to use two BlinkM Leds at the same time with the EZB 4.2

the old method from @Rich

I2CWrite(0,0x09,"A",0x0a) is not working..
after I start the EZ-Script, the blinkM is working only with 0,0x09.

in the data sheet of blinkM is "A" the only way to give a new adress.
but I2CWrite(0,0x09,"A",0x0a) has no effect.

how can help me ?
@fxrtst

I have found a few conversations, tutorials and activities that may help with your question. Take a look at these links. I've sorted them by what I believe to be most relevant but that is not always the case as I'm still learning.


Also, consider reviewing the Learn section for informative lessons and activities. Check it out!