All Tutorials / Rich / Ez-b V4 Connection Tutorial

Ez-b V4 Connection Tutorial

Description

Now I know there are video tutorials however sometimes it's cool to have a text/image based walkthrough which can be printed too. One of the first things you may want to do when you get your EZ-B V4 is to change how it connects. By default it acts as an access point which your PC or Mobile device will connect to. That's fine for some however I plan to have mine online and connected to my home network. In order to change...

Controls

This tutorial uses the following controls. Select a control to view the manual page.

Step 1

Now I know there are video tutorials however sometimes it's cool to have a text/image based walkthrough which can be printed too.

One of the first things you may want to do when you get your EZ-B V4 is to change how it connects. By default it acts as an access point which your PC or Mobile device will connect to. That's fine for some however I plan to have mine online and connected to my home network.

In order to change this you will need to connect to your EZ-B V4 while it is in "WiFi AP Mode". To do this is very easy. First power up the EZ-B V4. The EZ-B will be transmitting a wireless network named "EZ-B v4 2E" (where 2E is a unique number, mine just happens to be 2E, yours may be something different) so with your WiFi enabled PC or mobile device connect to this Wireless network. It is an open network by default so there should be no need to enter any passwords or codes.

Once connected the EZ-B V4 open up your web browser and enter the URL of 192.168.1.1 (you can access this through EZ-Builder also which I will cover later however I find this method allows you to skip the step of opening EZ-Builder).

Once you enter the URL you are greeted with the following page;
User-inserted image
Ignore my IP and the information the page gives about being client, I had already changed mine to Client mode

Once in here you can change the settings. First click on the button on the left labelled "Wi-Fi Client Mode"

You should then get this page;
User-inserted image

Now enter your SSID and password. Note, these are CaSe SeNsItIve!
User-inserted image

Now click on Connect.

The EZ-B V4 should make some noise and reboot itself. It's advised you power cycle once changing from adhoc to client (and vice versa).

The message should then play the default "Welcome to the EZ-Robot Revolution..." message followed by "I have connected to the network".

Once that is done, fire up EZ-Builder.

EZ-Builder has a built in IP finder, click on the icon as highlighted below;
User-inserted image

A new dialogue should pop up;
User-inserted image

Now select the range you want to scan;
User-inserted image

And click Start;
User-inserted image

Scanning should start, as indicated at the bottom of the dialogue;
User-inserted image

After a while it should have found all EZ-B V4s and listed them;
User-inserted image

Simply click on the one you wish to use then click select;
User-inserted image

The connection dialogue should be auto updated;
User-inserted image

Hit connect;
User-inserted image

It should then connect to the EZ-B;
User-inserted image

Now add your controls as you would have before (or if you are new, just check the other tutorials).
User-inserted image



As mentioned earlier, you can access the EZ-B V4 config through EZ-Builder also, this is done by clicking on the highlighted icon below (provided the IP to the left of it is the IP of your EZ-B V4).
User-inserted image

Steps