Revolution JD

Fuse Replacement

Introduction

Your robot's fuse protects the EZ-B from being damaged. This gives you protection from short circuits, Allowing you to safely operate your robot. This will guide you through how to replace your fuse if it has been blown.



What You Will Need

  • Your robot chassis or power base.
  • #2 Phillips Screw Driver.
  • ATM 20 amp fuse (automotive mini blade fuse).
  • Note: You can get these fuses at your favorite local hardware store.



Step 1

Click here for larger image

The fuse is located inside your robot. You will need to separate the chassis to access it. Observe the above illustrations to better understand how your robot is assembled.

Step 2

Click here for larger image

Remove the four screws in the bottom of the chassis.

Step 3

Click here for larger image

Separate the two halves of the chassis.

Step 4

Click here for larger image

Locate the fuse.

Step 5

Click here for larger image

Pull fuse away from its holder.

Step 6

Click here for larger image

Replace with a new fuse

Step 7

Click here for larger image

Reassemble your robot and now you are done!

Complete

You are now ready to use your robot! Advance to the next lesson - you are almost ready to be a EZ-Builder master!


Continue to Next lesson

Last updated 1/9/2015

Table of Contents




2. Blockly