HBridge - BV4113

How To Add This Control To Your Project

Step #1) Load the most recent release of EZ-Builder
Step #2) Press the Project tab from the top menu bar of EZ-Builder
Step #3) Press Add Control from the button ribbon bar of EZ-Builder
Step #4) Choose the HBridge category tab
Step #5) Press the BV4113 icon to add the control to your project


Description

EZ-Robot Certified HBridge Movement Panel. Always connects to Pin D0.

This is an EZ-Robot Certified Economy Motor Controller. It is capable of 1.5 Amps (5 Watts) between 5 and 12 volts DC. This convenient motor controller connects to the EZ-B by a single cable.

The cable to the EZ-B provides +5, GND and Signal for the Motor Controller Communication

The other connections are for your motors and motor power.

*Note: The IC on the board will get very hot if your motors draw too much current. Consider adding a heat sink to the chip: DigiKey Heat Sink







Related Tutorials & Activities

Movement Panels

Movement Panels

One of the powerful features of EZ-Builder is the concept of Movement Panels. A Movement Panel is a control which is responsible for how your robot moves in directions (forward, left, right, stop, r...

Last Modified on 2/11/2017

Created by EZ-Robot