Diy Awesome Project Case Made From Netgear Routers And Superglue

 
#1

OK pretty simple idea here. I have noticed actual project cases are usually very ugly and very expensive. Then even if you find a good deal it may be very difficult to get a similar or matching case later. Ooooh the problems today's nerds face right? Here I will show how I used 12 dollars worth of used and probably broken routers , a dremel and a few drops of super glue to make a cool case. Smile. I will use it to house a light , fan and ezb but you can customize your application!
User-inserted image

#2

I like it when a plan comes together,,, re-purpose, re-cycle, EZ.

#3

Super EZ! First step is grab two or three ( or more) matching routers. You can do this with most net gear routers , some linksys , bell in ext. First off routers are great looking and because they come out so often finding a used one or broken one on craigslist or eBay is usually easy.

First we need to take the router apart. I found I had to use a t4 security bit. I carefully marked the first router and after a few seconds of trimming I was able to line up the case and place some masking tape on them to hold them in place.
User-inserted image

User-inserted image

User-inserted image
I ran a bead around the seam both inside and out of super glue and the pieces were held secure by tape...
User-inserted image
Next I wanted to add an extra layer to make a triple stack... I carefully trimmed the edges again except this time I left the posts that the bottom panel can still screw to.
User-inserted image

User-inserted image

User-inserted image

#4

User-inserted image

#5

User-inserted image

#6

I'm making this case as a permanent replacement for the experimental led light and a ezb controller of course Winky. Here are comparison pics
User-inserted image
Side by side you can see one is twice as tall. That's more room for electronics Smile
User-inserted image

User-inserted image
My idea is to increase lighting to 2 or three rows of three LEDs for a total 60 to 90 watts wow!
User-inserted image
Three stacking the routers is perfect to fit two 60mm fans ( and double stacking will fit 3 40mm fans)

Blue LEDs are on the way from China. I have considered using the two whites I already have but I may replace them. In the future I'm mounting LEDs with screws for easy replacement.
User-inserted image

I will more than likely mount the ezb upside down for easy wire access from the bottom.

#7

Great tips Josh! THanks as always.

#8

Who says robots have to be Ugly , good Job!

#9

Thanks guys! I love to reuse cool items in different ways

#10

Most routers have useful tidbits inside them to. And they just look good with the air vents, good idea.