My 3d Design Cover For The Power Shell Or Six Body

 
#1

So continuing with some more 3D design. Here is a cover I have created for the Power shell or Six body. For now it slides over top with a friction fit (until I can figure out a way to lock it in place). It does nicely at covering and tidying wiring to the ezb. It also serves as a way to protect the ezb exposed pins so you don't do something stupid like I did and drop a screw driver on it (blowing a port or two) LOL... I also included a female ezbit connector on top... It's meant to fit over the injection molded ezb shell... It probably would fit a 3d printed case, but I haven't tried...
EZB4_PowerBase_CoverV3.stl

Creating a test print right now so I will post details of the finished design a little later (with the stls of course)
User-inserted image
User-inserted image
User-inserted image
User-inserted image

User-inserted image

#2

Again, a very nice job ! well done !

#3

Here is the STL... EZB4_PowerBase_CoverV3.stl

Printed on an UP! Plus 2
Friction fit
Printed at 250Microns
3 shells
ABS
Approx 3.5hr print time
Your results may vary...

#4

good to see you back on Richard!