#1

Hello I state that I am using the product from very little, I would ask how I can create the project in ez builder for the robot that I enclose a picture. Currently it works properly read with raspberry but I would use it exclusively with your product.
User-inserted image

#2

Looks like you need an EZBv4, (to replace the Raspberry) an EZ Camera and a battery pack. Download EZ Builder and you'll have it up and running in no time.

#3

crivellarodiego.82
Welcome, and that is a great looking robot.
EZ Robot and EZ Builder software is a great resource with a great community.
EZ Builder has an option for Auto Position that can help you create frames then combine them into actions for your robot.
Download EZ Builder software to try with out any purchase.
If you decide to purchase an EZ Robot controller you will not be disappointed.
Look at the EZ Robot JD file to get ideas how to get your robot moving and respond to voice recognition.
Steve S

#4

Thanks to everyone for the tips I did not think you had responded so quickly.
My question is to configure the servo MG996R because I downloaded the ez builder but they are not in bookstores. And being new does not know how to implement them.

#5

Let me know if you can turn my robot design and if you how to do that, I thank you but as mentioned are the first experience in EZ-Builder.

#6

EZ Builder will run your servos- no problem.

#7

Here is a link to the manual for Auto Position Control for EZ-Builder. The Auto Position Control makes your robot move in positions (walk, sit, stand, dance, etc): http://www.ez-robot.com/Tutorials/Help.aspx?id=180

Also, yes the EZ-B v4 will work with your MG996R servos Smile