Congratulations DJ Sures, for answering the question and has received an EZ-Credit award! Share what you have learned and create a tutorial to help others by clicking here.

Ez Builder Crashes

Assistance Requested

Help gwen4156 with their question and receive $10 of EZ-Credit to get more robots and parts from our store. The following information was provided about their previous efforts searching tutorials for a resolution.

gwen4156 claims to have checked these sources:

Hi, I'm using EZ Builder to control 2 EZB v3s and have a continued issue with crashes. I do have the latest version of EZ Builder and the firmware on both boards is up to date but each time I try to open my saved project I get the error message as seen in the attached photo. I've rebuilt the project several time and get the error most times I open my project. If I open the project multiple times it will eventually fully load and work but its a bit annoying.

Any ideas what may be going on?

User-inserted image

I have found a few conversations, tutorials and activities that may help with your question. Take a look at these links. I've sorted them by what I believe to be most relevant but that is not always the case as I'm still learning.

Also, consider reviewing the Learn section for informative lessons and activities. Check it out!


Can you post your project for me to review? I do not have a Sabertooth to test with and I believe there is a bug in the sabertooth module - at least that's what I can deceiver from the stack trace.

Reviewing your project will help me


Here it is:



thanks! i'l take a look for you today


Bummer, Now, since I've added more button assignments (PWM commands), My project will not load at all. Frown


Gwen, I'll confirm the project has a problem. I opened it from your link into my Win 8.1 laptop and I got the same message. I X'ed out of the message and the project loaded and had only 4 or 5 controls. Then I saved it to my desktop and tried to open it, got the message, x'ed out and only the Sabertooth control and MP3 Trigger control opened.

DJ's on the job and you can bet he'll get it figured out. Good luck.


It looks like it's the MP3 Trigger control. I deleted it and now everything loads OK for me. I see you have it set to board 1. I think the MP3 Trigger will only work on board 0. Try moving starting with the file you posted and make the change and see what happens.

EDIT: Nevermind. I tried a few things in the Trigger control and nothing helped. Hopefully DJ can find somthing.


OMG, Now that sounds simple doesn't it Dave... Winky

Board 0 is in the lower section, board 1 is in the upper section. The two robot sections are connected ONLY by a 30 amp Mercotac rotating connector

Oh, the pain... Lol,,,
Mercotac Slip Ring Connector


Wow, that's a cool little gadget. I wish I had know about this when I was building. I read a lot of posts where people were looking for something like this. I'll have to keep this in mind.

As far as the MP3 Trigger and the board that it assigned to I really think I remember it having to be assigned to board 0. However I may be wrong and I have no way to check as I've moved on to the V4. This also may have nothing to do with your problem loading. Sometimes I'm just no help but I try. *confused* At least I can give moral support. Winky


It is a cool gadget. Think "Golden Boy" Weeeeee..... Lol.

I did maintain a web page for 6 years or so. It was part of the 'old knowledge'... Winky