Award
Congratulations DJ Sures, for answering the question and has received an EZ-Credit award! Share what you have learned and create a tutorial to help others by clicking here.

I2c Camera Module

Assistance Requested

Help rb550f with their question and receive $10 of EZ-Credit to get more robots and parts from our store. The following information was provided about their previous efforts searching tutorials for a resolution.

rb550f claims to have checked these sources:
 
#1

Would it be possible to use an i2c camera module with EZB v3 or v4.? I found this on Ebay..640x480 VGA CMOS Camera Module OV7670 FIFO Buffer AL422B SCCB compatible wit I2C

$13.90
High sensitivity for low-light operation.
Low operating voltage for embedded application.
Standard SCCB interface compatible with I2C interface.
With AL422 3M-Bits FIFO.
Raw RGB, RGB (GRB4:2:2, RGB565/555/444),YUV(4:2:2) and YCbCr(4:2:2)output format.
Support VGA, CIF and from CIF to 40 x 30 format .
Vario Pixel method for sub-sampling.
Auto Image Control: AEC, AGC, AWB, ABF, ABLC.
Image Quality Control: Color saturation, hue, gamma, sharpness and anti-blooming.
ISP includes noise reduction and defect correction.
Support image scaling.
Lens shading correction.
Flicker 50/60Hz auto detection.
Color saturation level auto adjust.
Edge enhancement level auto adjust.
De-noise level auto adjust
Photosensitive Array: 640 x 480.
IO Voltage: 2.5V to 3.0V.
Operating Power: 60mW/15fpsVGAYUV.
Sleeping Mode: <20µA.
Operating Temperature: -30 to 70 deg C.
Output Format: YUV/YCbCr4:2:2 RGB565/555/444 GRB4:2:2 Raw RGB Data (8 digit).
Lens Size: 1/6".
Vision Angle: 25 degree.
Max. Frame Rate: 30fps VGA.
Sensitivity: 1.3V / (Lux-sec).
Signal to Noise Ratio: 46 dB.
Dynamic Range: 52 dB.
Browse Mode: By row.
Electronic Exposure: 1 to 510 row.
Pixel Coverage: 3.6µm x 3.6µm.
Duck Current:: 12 mV/s at 60?.
PCB Size (L x W): Approx. 1.4 x 1.4 inch / 3.5 x 3.5 cm

VGA OV7670 Camera Module x1
User-inserted image

I have found a few conversations, tutorials and activities that may help with your question. Take a look at these links. I've sorted them by what I believe to be most relevant but that is not always the case as I'm still learning.


Also, consider reviewing the Learn section for informative lessons and activities. Check it out!


#2

No. You can use the ezrobot camera though.

#3

There's no way to get the video from the ezb-b translated and into EZ-Builder.

#4

Thanks DJ and Technopro for fast response...

#5

I2c is too slow as well. It's max speed is only a few hundred hz which will only give you a few frames a second anyway