Temp/Humidity Sensor

 
#1

Hi Guys,
I want to hook up a temp/humidity sensor to my bot and was looking at this probe. http://www.allelectronics.com/make-a-store/item/THS-75/TEMPERATURE/HUMIDITY-SENSOR-W/LEADS/1.html
User-inserted image
Any ideas how I would wire it up to the EZ-B?

#2

Given this: 2.1 Power Pins (VDD, GND)
The supply voltage of SHT7x must be in the range of 2.4
and 5.5V, recommended supply voltage is 3.3V.
Decoupling of VDD and GND by a 100nF capacitor is
integrated on the backside of the sensor packaging.
The serial interface of the SHT7x is optimized for sensor
readout and effective power consumption. The sensor
cannot be addressed by I2C protocol, however, the sensor
can be connected to an I2C bus without interference with
other devices connected to the bus. Microcontroller must
switch between protocols.
Can I attach the power leads to DIO and the communication leads to AIO?

#3

It looks like i2c to me. Except they don't call it that - probably due to licensing issues with Philips. Might need an additional pull-up resitor, not sure though.

#4

I'd use an analog one, save yourself the trouble of playing with i2c values www.ebay.com/sch/i.html?rt=nc&LH_BIN=1&_nkw=temperature+sensor+analog&_trksid=p3286.c0.m301

you can also get humidity ones too i'm sure

#5

Thanks Smile