Rad 2.0 Mech Warrior #3 Air Soft And Nerf Missiles

 
#11

You should give yours gun arms lol. On ebay these guns are 20 dollars each and run on 6v fully electric. Also the nerf swarm is 20 dollars too. It would be awesome to start a trend of miniature warfare ez robots lol. Just remove the arms cut a knotch for a servo on each side for up and down aiming and use screws to attach the airsoft toy gun directly to the servo. Easy beans!

#12

6V power sonic batteries came in. Im not sure why I ordered these... oh ok the rad robots electronics. Anyways they are here when I needs them.
User-inserted image

#13

Very cool project jstarne1!

I look forward to seeing video's of it. I trashed my AR drone but after I perfect my robotic skills on the ground, I'm going to repair my drone and equip it with a cannon of some sort. I believe the gear box of those airsoft guns are under 185 grams?

Here's a video of a projectile using a hydrogen chloride fuel source. It's initiated by an ultra violet LED. I would replace replace the glass tube with plastic.


Click To Watch Video

#14

Thanks buddy. Tommorow this rad robot gets some mods. I will post pics. Hopefully before the days end I will have the gun arms aiming

#15

Ok first step on my list was to make more room by swiftly removing the cupholder to fit larger batteries.
User-inserted image

Filling a inside and outside curve is too difficult to do at once so I taped it off and did one half
User-inserted image

User-inserted image

User-inserted image

Ok done! Just need to peel off the rest of the tape and the hole is filled and also follows the three body lines already there.

#16

Next I wanted to fill the large empty arm holes that are unsightly and I also need a good surface to mount servos for the mini gun tilt in each side.
User-inserted image

User-inserted image
Ok so the shoulders have been filled in with abs plastic

#17

User-inserted image
Lucky me the mechanics are all left contained in this


User-inserted image

#18

Wow, it is really coming along. And looking good.

#19

My problem at the moment is somthing on this one robot is causing any paint or even sealer to wrinkle bad. Im going to sand all the way down to bare plastic and clean it. :/

#20

Ok I started sanding between late last night and today this is what ive done...
User-inserted image

User-inserted image

User-inserted image

User-inserted image