I've recently finished creating my robot with the developer kit and everything is fantastic!
I'm just a little confused with the continuous servos, I've got one on each side of my robot for the wheels, however when I control it to move forward, I have one wheel moving forward and the other moving in reverse.
this is probably me being really stupid but how do I resolve this?
I have found a few conversations, tutorials and activities that may help with your question. Take a look at these links. I've sorted them by what I believe to be most relevant but that is not always the case as I'm still learning.
Also, consider reviewing the Learn section for informative lessons and activities.
Check it out!
You have a few options:
1. You can physically take the servo off the robot, turn it 180 degrees and then place it back on the robot.
2. If you are using a continuous rotation Movement Panel in EZ-Builder you can just swap the forward and Reverse values (instead or Forward = 180, Forward would be = 1, and vice versa for Reverse)
Hopefully that helps