Award
Congratulations proteusy, for answering the question and has received an EZ-Credit award! Share what you have learned and create a tutorial to help others by clicking here.

Connecting The Ln Motor Board

Assistance Requested

Help Nomad 6R with their question and receive $10 of EZ-Credit to get more robots and parts from our store. The following information was provided about their previous efforts searching tutorials for a resolution.

Product: (click to view product details)

EZ-Builder Controls: (click to view manual page)

Nomad 6R claims to have checked these sources:
 
#1

hi

i read this tutorial,i wanna connect motor board with 1pwm.

witsh port do i use to set the pwm ?
and where does the power come from to power the motor board ?


tutorial motor board

I have found a few conversations, tutorials and activities that may help with your question. Take a look at these links. I've sorted them by what I believe to be most relevant but that is not always the case as I'm still learning.


Also, consider reviewing the Learn section for informative lessons and activities. Check it out!


#2

ok it doesn work.on witsh need the pwm be? the white D16 ?

the board lids up red led.i used rich tutorial.not one direction works.

#3

i try dj config,stil not moving.do i need a script ot adjust init ?
the board lids up,but see no movement on the boards from leds.

any one thank you

#4

I just use the H-Bridge Movement Panel and have my digital outputs conected.
Then you can use the arrows to move the motors.

User-inserted image

#5

ah good info.problem i have is am using a second ezbv4.

User-inserted image

#6

its very confusing cause diff colors are used.for now i have only backwarts.


User-inserted image




diff colors

#7

found it,got all direction correct.

thank you very much proteusy