Single Servo Buzz Control V2

Author: Aerius
Created: 2/14/2016
Updated: 2 years ago
Filesize: 92,836
This script will automatically apply a release command after a servo has done his last movement If needed, it will be used to stop the buzzing noise when a servo is in standby holding position. 1- make sure there is no physical obstruction 2- define minimum and maximum movement value 3- Caution: use this script only if the mechanism assembly can hold position when the servo is released. The D23 Servo Buzz script will start when a connection is made to EZB For a demo, run the "Test multiple values" script and observe the servo control window turning to red when released. The servo will be released +/- 1sec after his last movement, no matter how long or at what speed it will do.
Load the robot project into EZ-Builder
Purchase EZ-Bits for this robot